Large Rear Wing Spoiler – Tesla Model 3 (2017-2022)

149,54

SKU: M31722SLW-GB Categories: ,

Large Rear Wing Spoiler – Tesla Model 3 (2017-2022)

The installation

1. You’ll need to clean the back of the car thoroughly. You can do this by washing the car with soap or use a warm, damp cloth. Either way, be sure the back of the car is as clean as can be.

You see us use a damp cloth and silicon wax remover. Silicon wax remover is recommended, but optional.

DO NOT use anything that contains wax to clean the car, like certain car shampoo.
DO NOT use the supplied alcohol wipe in this step. We use this wipe in step 5.

2. Place the spoiler, with the red tape still on in the inside, on the car. Measure the ends of the spoiler to the edges of the trunk and make sure the spoiler is sitting perfectly in the middle.

3. Once placed and aligned, cut 2 short pieces of tape. Place 1 piece in the middle of the spoiler and the other on the car, making a perfect straight line.

4. Use an alcohol clean wipe to clean the area where the spoiler is going to be place. Clean thoroughly!

5. Remove the red tape from the spoiler and place one end in the right corner. Use the tape on that car to make sure it is placed in the proper spot. Then slowly place and push the spoiler onto the car, moving from the starting corner towards the other corner. Do it slowly and carefully. Use pressure when applying a new section of the spoiler onto the car. After the spoiler is placed, pressure few centimeters at a time again.

6. OPTIONAL Heat a section of the spoiler with a heatgun or hairdryer. Then push and hold that area for ~20 seconds while it’s cooling down. Do this for the whole spoiler. The adhesive will soften a bit, but will work faster and better!

DO NOT heat it too much or you might damage the spoiler and/or paint of the car. We only need to heat the surface and spoiler a bit. Don’t need to grill or fry an egg on it.

* We used a heatgun, but the hairdryer of your daughter, girlfriend or wife will also do! 😉

7. The installation is done and we recommend to leave this on for at east 10-12 hours.

If you have any problems or concerns, contact us, or send as a DM on Instagram or Facebook.

Colors

Glossy Black, Glossy Black & Red, Carbon Fibre Print

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.